Gearless Lift Machine
WSG/WGG-29
Operating Instructions
Code
GM.8.002662.EN
Date
04.02.2019
Version
0.19
Page
30
Subject to changes without notice ! Subject to changes without notice !
EN
1
. Install the lever block (1) in a suitable location
in the vicinity of the lift machine, e.g. on the
machine frame.
2
. Insert the Bowden cables – the ends with the
spring (5) – into the manual release lever (4)
and the counter-holder (6) of the brake (3).
1
2
3
4
6
5
ca.
65 Nm
0,5
m
ca.
130 N
4
5
6
2
3
. Insert the Bowden cables (2) into the holders (7)
and (8) of the lever block (1) with the lever (9)
untensioned (see picture below).
Caution:
Install the Bowden cables symmetrically.
Note the different configurations when using two
or three brakes.
9
1
7
8
2
2 brakes
3 brakes
8
8
Danger
Lock the car and the counterweight and ensure that all of the necessary safety precautions
are observed for the lift system. The lift may move in an uncontrolled manner.
Install the manual releasing device while the brake is disconnected from the power supply.
(Rear side of the brake)
10.4. Remote brake control by Bowden cable
The Bowden cable remote control is used to
release the brakes mechanically in the event
of an emergency. See section 6.5
"Emergency evacuation" for details.
The standard length of the Bowden cable is
3 m. Other lengths are available on request.
Installation
430
(<425)
500
13
9
79
97
86
70
43
0
39
0
R 6
,75
Dimensions of the lever block
