Installation and Operational Instructions for ROBA
®
-diskstop
®
Type 894.5_ _._ _ Size 10
(B.8.4.5.EN)
23/03/2017 TK/TL/GC/SU
Chr. Mayr GmbH + Co. KG
Eichenstraße 1, D-87665 Mauerstetten, Germany
Tel.: +49 8341 804-0, Fax: +49 8341 804-421
Page 9 of 16
www.mayr.com
, E-Mail:
info@mayr.com
Table 1: Technical Data
Max. braking force:
11182 N
Min. braking force:
4551 N
Braking force tolerance:
0 / +60 %
Max. friction work
1)
Q
r max.
per braking action:
400000 J
Brake disk diameter D:
650
– 1500 mm
Effective friction diameter D
eff
:
D
eff
= D
– 80 mm
Max. trigger speed:
25.1 m/s
Brake disk width (+0 / -0.15 mm):
25
– 30 mm
Nominal voltage U
N
:
see Type tag
Overexcitation voltage U
O
:
2 x U
N
Coil capacity at nominal voltage P
N
:
see Type tag
Coil power at overexcitation P
O
:
4 x P
N
Overexcitation time t
O
:
1
– 2 s
Max. air gap "a" (Fig. 2) after wear
1.8 mm
Protection (electrical):
IP54
Protection (mechanical):
IP10
Duty cycle with 180 switchings per hour:
60 %
Electrical connection of the magnetic coil:
2 x 0.88 mm
2
Electrical connection of the microswitch:
3 x 0.5 mm
2
Hand release force:
approx. 400 N
Hand release stroke:
> 3 mm
Tightening torque Item 5 :
10 Nm
Tightening torque Item 9:
410 Nm
Tightening torque Item 10:
710 Nm
Tightening torque Item 17:
10 Nm
Tightening torque Item 20:
10 Nm
Ambient temperature:
-5 °C to +40 °C
Mass:
76 kg
DANGER
If the brake is operated with air gap "a"
> 1.8 mm, it becomes a
safety risk
as the braking effect is no longer given
because the armature disk (2) lies again the hand release (6).
1)
The thermal load for a brake cannot be stated. Most of the brake energy is transferred onto the brake disk.
The thermal load capability is dependent on the heat dissipation capacities of the brake disk.