Subject to changes without notice !
Änderungen vorbehalten !
Gearless Lift Machine
WSG-25
Operating Instructions
EN
Code: GM.8.002673.EN
Date:
07. May 2019
Version: 0.13a
Page: 34
12.4.2. Installation when retrofitting systems
DANGER
f
Lock the car and the counterweight and ensure that all of the necessary safety precautions are observed for the lift
system. The lift may move in an uncontrolled manner.
f
Install the manual releasing device while the brake is disconnected from the power supply.
1. Install the lever block (1) in a suitable location in the
vicinity of the lift machine, e.g. on the machine frame.
2. Insert the Bowden cables (2) – the ends with the spring
(5) – into the manual release lever (4) and the counter-
holder (6) of the brake (3)
ca.
130 Nm
0,5
m
ca.
260 N
1
2
3
4
6
5
4
3
5
6
2
(Rear side of brake)
3. Insert the Bowden cables (2) into the holders (7) and (8)
of the lever block (1) with the lever (9) in the rest position
(see picture below).
Caution.
Install the Bowden cables symmetrically. Note
the different configurations when using two or three
brakes.
9
1
7
8
2
(Lever (9) in
rest position)
2 brakes
3 brakes
8
8
4. Tension the Bowden cables on the lever block (1) using
the nuts (10 and 11) on the threaded rod (12). The manual
release levers (4) of the brakes (3) must not move.
Caution.
Do not operate the lever (9) during tensioning (in
rest position).
The brakes must not be released
.
9
10
12
11
2
1
