21.05.2015
E
Gearless Synchronous Lift Machines
WSG09.X
Operating and maintenance manual J40003
Page 27
Date
Version
Subject to changes without notice!
12.8. Replacing the measuring system
The measuring system is only accessible from
the rear side of the motor.
Disassemble the measuring system only if this
is necessary because of a defect. Remember to
readjust the offset value after reassembly (see
the converter operating instructions).
Disassembly
r
Loosen the clamping ring on the measuring system (2mm
Allen screw).
r
Remove the M5x45
fastening
screw
r
Insert the M5x10 setscrew to protect the thread (see
gure) and remove the measuring system by means of the
M6x60 forcing screw.
Please take attention TS5213N2503
requires different encoder cable.
r
Plug in the measuring system
r
insert the M5x45 fastening screw in the hollow shaft and
tighten the screw
r
Tighten the clamping ring on the measuring system
Assembly TS5213N2503
r
Plug in the measuring system
r
insert the
x
in the hollow shaft and
i
r
