Commissioning
5
Translation of the original operation manual
25
25
•303_208176_1004_en•ski
5
Commissioning
To avoid unnecessary work interruption, take absolute care that the containers/drums are
not running dry thereby causing the pump to suck air.
If this does happen, the system switches off automatically. In this case, bleed the system
thoroughly and start again from the beginning.
Please absolutely ensure that all hoses and pumps are used only for the provided com-
ponents (A or B).
Static charges can cause sparks which can lead to fire and explosions.
Due to possible electrostatic charge, DO NOT use narrow neck cans or drums with bung-
holes. With metallic containers, take care that the Spray gun* is constantly in contact
with the container wall.
Pressure values listed in this chapter are only
guideline values
and eventually have to
be adjusted according to the
viscosity of the material
or the
hose length being used
.
While working, observe if you have to adapt the pressure to get the desired result.
All position numbers found in this chapter apply to the specification in the chapter 3.6
“Component description”.
Task: Cleaning the whole material circuit with thinner and filling it with the des-
ignated material.
Initial situation:
The work with the unit has not started:
➤
make sure the STOP button (Pos. 1.2) on the control cabinet is still pushed
➤
all shut-off levers on all components are closed
➤
all air regulators are set to 0 bar
➤
all accessory equipment is shut off and the power connection is cut.
1. Step: Cleaning the area from the material container to the mixer
➤
Before initial operation, open high pressure filters (pos. 4) with hook spanner and
ensure that clean, suitable filters are inserted.
➤
Fill the containers (pos.. 7 A / B) on the unit with the thinner recommended by the
material manufacturer.
WARNING!
Parts of the hand can be crushed or cut while lowering the drum cover onto the
container edge.
Never hold parts of the body (finger, etc.) in the area of the container edge and drum
cover! Make sure that no clothing gets caught in this area or pulled into the container!
Base component
(A) = Blue
Hardener
(B) = Red
