Preface
1
Translation of the original operation manual
5
•303_208176_1004_en•ski
1.2
Warning instructions
1.2.1 Warning instructions on the unit
Warning signs and symbols which have been placed on the machine are there to inform
of possible dangers and must be observed.
Warning signs and symbols may not be removed from the machine.
Damaged and illegible warning signs and symbols are to be replaced immediately.
The following signs are located on the machine:
➤
Warning sign covering the grounding of the machine (picture 1.1):
On high pressure filter:
The proprietor is required according to the German Accident Prevention Regula-
tion („Unfallverhütungsvorschrift“) BGR 500, Kap. 2.29, to ensure that the ma-
chine is properly grounded.
Please, observe our instruction manual!
➤
Nameplate (picture 1.2)
On the control cabinet of the 2K-Unit
Please observe that the information located on the nameplate corresponds to data
found on the machine card. We request immediate
notification
should there be any
discrepancies
or if the nameplate is
missing
.
➤
More nameplates for the sub assemblies are placed on the:
➤
Flush pump
➤
Air pressure motor
➤
Material pump A + B
➤
Feed pumps A and/or B (depending on model)
➤
Material fluid heater
➤
Safety instruction sheet (picture 1.3)
There is a safety instruction sheet with the most important safety instructions attached
to the machine (picture 1.3).
Nevertheless
, please adhere to all the other instructions
in the user’s hand book.
1.2.2 Note about the guarantee of the product
Rebuilds and changes
For safety reasons, it is not allowed to carry out rebuilds or changes without authoriza-
tion.
Protective equipment may not be dismounted, changed or neglected.
If using components which are not produced or delivered by
, warranty cover-
age is negated as well as liability.
The machine may only be operated within the prescribed limits and machine parameters.
Picture 1.1
Picture 1.2
Picture 1.3