Translation of the original Operation Manual
11-9
•1307_PU280_SV1018DV1020_BAoDB_en•ski
en
Optional equipment
1.
Connect the material valves to the connection block
2.
Operate the trigger on the spray gun once again
3.
Close the air pressure valve and pull off the compressed air hose
4.
Loosen the fastening screws on the connection block
➤
Lubricate the air inlet every day with 2 - 3 drops of spray gun oil.
➤
Lubricate the grease nipple regularly with grease, until clean grease appears
in the module receptacle,
(Figure 11.17)
.
Grease
Figure 11.16
➤
Soiled or damaged material filters can cause malfunctions in the spraying
process, such as e.g. overpressure of a component.
You should therefore clean the filters in regular intervals.
➤
Use the material filters recommended by the material manufacturer for your
spraying material. Make sure that each O-ring that is applied to the filter is
clean and free of damage.
k
Pos. Designation
1
O-ring
2
Material filter
Figure 11.17
11.3.8 Dismantle the
spray gun
11.3.9 Spray gun
maintenance
Lubrication
Filter change
Note!
The filter size depends on
the mix module used!
Summary of Contents for DUOMIX PU280
Page 68: ......