Translation of the original Operation Manual
11-10
•1307_PU280_SV1018DV1020_BAoDB_en•ski
en
Optional equipment
➤
Replace the mix module before it is worn.
Using a worn module will cause extremely high paint consumption and ad
-
versely affects the quality of material application.
➤
Disassemble the spray gun from the block, as described in chapter
Dismantle the spray gun”, p. 11-9
before you start the replacement.
➤
After removing the
front cap
(
), of the round jet nozzle (
)
and the mix module
(
)
check the inlets and outlets of the filter element and the mix module for
cleanliness and possible blockage.
Use a drill of appropriate diameter to remove possible material residues.
➤
Use the mix module size recommended by the material manufacturer for your
spraying material.
Pos. Designation
1
Spray gun body
2
Mix module
3
Round jet nozzle
4
Front plate
5
Screws
Figure 11.18
➤
Assemble the mix module as follows:
➤
Slide the module with the smaller diameter forward over the valve rod in
the spray gun body.
Carefully align the pin of the module in the recess of the module seat ring.
Press the module firmly into its seat,
(Figure 11.20)
.
Check the correct seat of the pin once again.
Figure 11.19
➤
Check the round jet nozzle for cleanliness. The nozzle can be cleaned with
a drill of appropriate size.
➤
Apply a slight amount of grease to the round jet nozzle. Slide the round jet
nozzle over the mix module.
Note!
Mix module and round jet
nozzle as well as cleaning
drill must be matched to
each other.
The size of the mix module
depends on the material to
be processed Consult your
material manufacturer!
Changing the mix module
Attention!
Filter and mix module
must always be kept clean
to avoid malfunction of the
spray gun.
Summary of Contents for DUOMIX PU280
Page 68: ......
