Translation of the original Operation Manual
4-1
•1307_PU280_SV1018DV1020_BAoDB_en•ski
en
4
Installation and Assembly
➤
The material to be applied is readily available.
➤
Prepare the material by following the instructions of the material manufacturer.
All materials to be sprayed must be supplied from the manufacturer with data
concerning viscosity, application temperatures, mixing ratios, etc. If this is not
the case, consult the corresponding manufacturer and ask for these data.
For optimal preparation of the spraying materials
offers a wide range
of accessories, like e.g.:
➤
Agitators in various sizes
➤
Material preheating containers
➤
The compressor power must match the air requirements of the equipment, so
that an adequate air supply is ensured, see chapter
.
➤
The diameters of the air supply hoses must match the connections on the
equipment.
➤
Stand the unit on a level and firm base.
➤
Consider the required floor space - see chapter
“13.1 Technical data”, p. 13-1
.
➤
All operating elements must be easily accessible.
➤
The access to the safety features must be kept clear.
Various system components were removed and packed in a separate cardboard
box for transport.
1.
heated hose package
2. Spray gun (optional)
Material emerging from the connections can cause severe physical injuries
and damage to property. Check all rotatable parts, nuts, screws and hose
connections and tighten these properly.
➤
Check the permissible highest pressure for material hose, spray gun and ac
-
cessories. It must be higher than or equal the maximum operating pressure of
the equipment as specified on the type plate or the machine card.
➤
Compare the maximum operating pressure of the safety valve with the specifi
-
cations in the machine card or the type plate. These data must match.
Prerequisites
4.1 Setting up
the unit
4.2 Assembling
attachments
and acces-
sories
Summary of Contents for DUOMIX PU280
Page 68: ......