Translation of the original Operation Manual
11-11
•1307_PU280_SV1018DV1020_BAoDB_en•ski
en
Optional equipment
➤
Mount the front cap over the round jet nozzle with the three screws,
(Figure
11.19)
.
Tighten the screws very tight (SW 8).
Slightly grease the front face of the front cap.
1.
Disassemble the spray gun from the connection block.
Figure 11.20
2.
Dismantle and clean the spray gun.
Pos. Designation
1
Spray gun body
2
Mix module
3
Round jet nozzle
4
Front plate
5
Screws
6
Filter element
7
O-ring
Figure 11.21
➤
Remove all material residues from all parts and material conducting passages.
Use a cleaning agent soaked cloth to remove deposits (e.g. caused by spray
fog) from the spray gun.
3.
Clean connection block
➤
Clean the outside of the connection block with a cloth soaked in cleaning
agent.
➤
Thoroughly remove any material residues from the material outlet opening.
4.
Grease the contact areas on spray gun and connection block.
11.3.10 Clean spray gun
Attention!
Never submerge the spray
gun in solvent for cleaning,
since this will cause dam
-
age to the O-rings and the
slide valve of the trigger.
Attention!
Use only lubrication
greases recommended by
the material manufacturer.
Summary of Contents for DUOMIX PU280
Page 68: ......
