Translation of the original operation manual
HERKULES PFP
21
HERKULES PFP_BAoDB_en_1402_B · rs
Transportation, installation and assembly
Safety measures at the place of installation:
➤
This unit requires a solid base and suffi
-
cient free space for safe operation.
➤
Secure the unit at its final location to pro
-
tect it against unintended movement. To
do this, engage the wheel brakes on the
swivel rollers (see Fig. 7).
➤
Always keep the working area, especially
all walkways and standing areas, clean
and tidy. Immediately remove any spilled
material and solvents immediately.
Fig. 7: Wheel brake
➤
Always ensure adequate ventilation at the work place to avoid damage to
health and material objects. At least a 5-fold air exchange must be ensured.
➤
Always observe the processing instructions issued by the material manu-
facturers.
➤
Even though there are no legal directives for low-mist Airless spraying
methods, all hazardous solvent vapours and paint particles should be
extracted.
➤
Protect objects adjacent to the spraying object against possible damage
caused by the material mist.
4.3 Assembly
WARNING
If assembly work is carried out by people who have not been trained for this
work, you endanger yourself and other people and impair the safety and
reliability of the unit.
➤
Electrical components must only be mounted by trained time-served
electricians – with all the other components, e.g. the spray hose and the
spray gun being assembled by trained personnel only.
The spray gun material hose and the spray gun were separately packed for
transport. Please assemble these parts before using the unit for the first time.
WARNING
Components that do not comply with the maximum permissible operating
pressure may burst und cause severe injuries.
➤
Before assembling, check the maximum permissible pressure for the
separately packaged components and accessories. lt must be higher
than or equal to the maximum operating pressure of the unit as specified
on the type plate.
➤
Compare the maximum operating pressure of the safety valves with the
specifications in the machine card or on the type plate. These data must
match!
