Cleaning the spray tip
1.
Close the air supply valve on the spray unit.
2.
Perform a complete pressure release on the spray unit.
3.
Completely depress the lever of the spray gun to pressure release it.
4.
Lock the spray gun.
5.
Unscrew the swivel nut.
6.
Remove the air cap and spray air from front to back through the spray tip.
7.
Reinstall the air cap and turn it to the desired position.
8.
Screw the swivel nut on securely.
Replace the spray tip before it is worn out. Worn tips increase
material consumption and reduce the quality of the finish.
Cleaning the filter
Clean the filter regularly, depending on the paint used, and at each material
change. This will prevent material deposits which make disassembly impos-
sible.
1.
Perform a pressure release on the spray unit.
2.
Completely depress the lever of the spray to pressure release it.
3.
Lock the spray gun.
4.
Using a 17mm open-end wrench, loosen the fluid tube lower while using
a 13mm open-end wrench to hold the fluid tube upper.
5.
Twist the filter down out of the fluid tupe upper.
6.
Clean the filter with a (non-wire) brush.
7.
Remount the filter in the opposite order.
Take care that the gasket in the fluid tube upper is correctly
seated.
Translation of the original operation manual
29
SPAC_Optima2100_1302_en • 0550012 • jw
Maintenance and repair
Summary of Contents for OPTIMA 2100
Page 2: ......
