WIZ127SR User’s Manual
28
is finished, make an Ethernet packet with all data in its serial buffer and send it to the peer
system via Ethernet. If WIZ127SR receives another byte from UART before the specified time
is expired, it restart timer and add the received one to the end of serial data buffer.
(‘0’:
Function Disable)
Inactivity
: When there is no data transmission, the connection will be closed
automatically after the
time specified in the Inactivity time. If the default value ‘0’ is set as the
Inactivity time, the network connection is maintained even though there is no
data
transmission. In order to close the connection, you should use the ‘Close’ commands. This
function is useful when you have two or more systems which are connected to the WZ127SR
module. When one system is connected to the WIZ127SR, other systems cannot connect to
the module simultaneously. If you defined a time in the Inactivity time, the other system can
connect to the module after the inactivity time elapsed. Inactivity Time can also be used when
the server system is unexpectedly shut down. In this case, there will not be any data
communication. After the time defined in the Inactivity time elapsed, WIZ127SR will close the
connection and enter into waiting state.
Reconnection
: The connection retry interval. (Client mode only)
5)
Serial Configuration
This function is for module configuration not through network with configuration tool, web
configuration and telnet but through serial communication. At the default status, the serial
command mode is disabled. When you want to set WIZ127SR via serial communication, check
“enable”.
