background image

1.        Power LED
2.        Module 1 : Water jet; bubble jet; video; basket up; lead 
single missile
3.        Throttle/Yaw control stick
4.        Throttle trim
5.        Yaw trim
6.        40% agility
7.        60% agility
8.        80% agility
9.        LCD display
10.      Power switch
11.      Antenna
12.      Roll (when 100%)
13.      Direction control stick
14.      Forwards and backwards trim
15.      Crab trim
16.      100% agility
17.      Lighting control
18.      Module 2 : Taking photos(Headless mode if available, 
press 2 sec)

Insert the battery by sliding the cover down. Then insert 6 x AA 
batteries as indicated under the cover.

Headless mode

How to fly

The headless mode means that the quadcopter's direction of flight seen from your viewpoint follows the controls directly, no matter 
in which direction the quadcopter is pointing. This is also referred to as 'Care Free' (CF) mode. This is usually done with a digital 
compass. So if you press the stick on the RX to the left the quadcopter will fly to the left from your viewpoint. Without headless 
mode the quadcopter would fly to the direction which is on the left side of the quadcopter, so if the quadcopter is pointing towards 
you it would fly to the right.

 - Using the throttle you can control the rotation axis of the drone. Using the directional joystick you can control the flight direction 
of the drone.
 - The mode available on this model is the mode 2 with the layout of the throttle on left. It is not possible to switch mode on this 
model.
 - The different calibration buttons help keep the drone stationary. Test this by pressing the accelerator and calibration buttons to 
maintain the drone in one place.
 - You can choose the percentage of the speed. The higher the value, the faster the reaction will be (e.g. 100% will be more 
responsive than 40%).
 - The two module buttons are used to activate different modules : photos / shots / basket.

Headless Mode Operation : Straighten the copter (red blades are in front) , long press Headless Mode button 2 seconds to enter 
into Headless Mode, the transmitter will start beeping; Long press Headless Mode button 2 seconds to exit, the transmitter will 
stop beeping.

Copyright WLtoys.eu | DroneX BV

Summary of Contents for Q282J spaceship









Reviews: