27
-
1.1.97.97.3.255:2
Note that 3-5 minutes polling was added in the last firmware (v2.68).
If those values make change, it will send a push message (push object (read only),
IP address, the values if the three objects above).
Elster Electricity Meter reading DLMS parameters, registers:
-
Addresses: (client, logical, physical)
-
Authentication: (mode, password)
-
object list
If the
“
object list
”
remains empty the polled object are the listed values. If other
object codes needed, use the notation above (dots, semicolon attribute separated
by commas).
Set in
AMM/DLMS
parameter group, at
“DLMS client” section.
The DLMS Push Parameters:
-
Addresses: (client, logical, physical)
-
Authentication: (mode, password)
-
target IP address (IPv4 Only) and TCP port.
Set in
AMM/DLMS
parameter group, at
“DLMS push” section.
10. When you have finished the configuration, choose the
Parameter write
icon
to send the changed settings to the modem. The status of the configuration
process can be seen at the bottom of the screen. At the end of the upload, the
modem will be restarted and operating according to the new settings.
Summary of Contents for WM-E3S
Page 13: ...13 ANTENNA MODEM...
Page 18: ...18 2...
