Installation and start-up
8
Requirements:
Coffee machine installed and connected to
water and power supply.
See chapter 1.1 – 1.2.2
Basic setting
Switch on the machine. Check the start-up date and time and
change them if needed and confirm the start-up date.
Confirmation is requested only when switched on for the first
time.
The date setting starts the maintenance counters and service
intervals.
Check date and time
(One-time query when switched on for the
first time)
Caution: The date can NOT be changed
later!
The machine fills up automatically and heats up
Language selection
System
>
Language
Enter the measured water hardness on the information pad
Activate any pre-rinsed water filter under System and enter the
filter capacity taken from the cutting table.
System
>
Water filter
(Service PIN must be entered)
Check machine options and correct if necessary:
Power Class, Low pressure, RDA, External Tank, Accounting ...
Service
>
Machine configuration
(Service PIN must be entered)
Enter the Service address(es)
Service
>
Service address(es)
Enter the machine name for the data back-up filename.
E.g.: Serial number and name of the company
Service
>
Machine master data
