MODEL: DHUR-AZ53
Wistron Neweb Corporation
17 of 21
Integration instructions for host product manufacturers
Applicable FCC rules to module
FCC Part 15.247
Summarize the specific operational use conditions
The module is must be installed in mobile device.
This device is intended only for OEM integrators under the following conditions:
1)
The antenna must be installed such that 20 cm is maintained between the antenna and
users, and
2)
The transmitter module may not be co-located with any other transmitter or antenna
3)
For all products market in US, OEM has to limit the operation channels in CH1 to CH11 for
2.4G band
by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user
regarding
to Regulatory Domain change.
As long as 3 conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed.
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID can not be used on the final product. In these circumstances, the
OEM integrator will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization. The OEM integrator has to be aware not to provide
information to the end user regarding how to install or remove this RF module in the user’s
manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this
manual.
Limited module procedures
Not applicable
Trace antenna designs
Not applicable
RF exposure considerations
20 cm separation distance and co-
located issue shall be met as mentioned in “Summarize the
s
pecific operational use conditions”.
Product manufacturer shall provide below text in end-product manual
“This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.”
Antennas
Brand
Model
Type
Peak gain ( dBi )
Connector 2400~2483.5MHz 5150~5250MHz 5250~5350MHz 5470~5725MHz 5725~5850MHz
WNC
WF1_ANT
PIFA
NA
3.16
2.17
1.71
1.49
1.61
WNC 81.EK615.GAA PIFA
IPEX
2.26
6.34
6.34
6.54
6.93
WNC 81.EK615.GAF PIFA
IPEX
3.09
4.23
4.23
5.35
4.06