Manual_S5_Airplus_2015_04_20
Page 43 / 68
©
Wodtke GmbH - Tübingen. All Rights and Changes Reserved.Printed 04/2015
Part No. 950 976
16.2 Basic Cleaning with Addi-
tional Actions
First carry out a complete basic cleaning accord-
ing to Chapter 15. Then perform the following ad-
ditional actions:
1. Inspect the cast grate for wear and replace
it as required. In case of curvature / warp-
ing of the grate of more than 1 mm (Fig.
73). In case of cracks in the material
(Fig. 74).
Fig. 73: grate with curvature / warping
Fig. 74: cracked grate
2. Check the vertical distance (A) between
the burner pot and the cast grate (Fig. 75).
The distance may not be greater than 1
mm. Adjust gap / clearance as required. To
do so, loosen the four screwed marked by
arrows.
Fig. 75: cast grate-burner pot clearance
3. If applicable (in case of stubborn soiling),
unscrew the burner pot for cleaning. The
burner pot is fastened by 4 screws. Clean
all air holes of the burner pot, such as with
a screwdriver.
Fig. 76: burner pot screw connections
Fig. 77: unscrewing burner pot
4. Inspect the seal under the burner pot for
wear and replace it as required. The as-
sembly is carried out in reverse sequence.
A
