Manual_S5_Airplus_2015_04_20
Page 40 / 68
©
Wodtke GmbH - Tübingen. All Rights and Changes Reserved.Printed 04/2015
Part No. 950 976
15.4 Correct Position of the Cast
Grate
1. Always insert cast grate (Fig. 72 Part A) up
to the stop (without force, flat side up!) so
that the door closes correctly.
2. If necessary, remove ash residue behind
the ash drawer and behind the cast grate,
as otherwise the ash drawer cannot be
completely inserted and the doors could
jam.
3. The edge of the cast grate must close off
circumferentially with the edge of the
burner pot (Part B).
There may be a maximum clearance of 1
mm between the cast grate and the burner
pot Fig. 72 (C).
Fig. 72: cross-section, grate and burner pot
15.5 Cleaning Surfaces
Powder-coated surfaces
should be wiped with a
damp cloth; do not scrub. Do not use scouring
agents or acidic/alkaline cleaning agents. Stub-
born spots can normally be removed with conven-
tional glass cleaner.
Galvanised parts
are best cleaned with our spe-
cial stainless steel cleaning spray or specialised
stainless steel cleaners. Wipe with a damp cloth;
do not scrub. Do not use scouring agents or
acidic/alkaline cleaning agents.
Decorative glass panes and glass panels
should be wiped gently with a damp cloth with nor-
mal glass cleaner, do not scrub. Stubborn spots
can normally be removed with conventional glass
cleaner.
Do not use wodtke's Special Glass Cleaner
for this
, this is only usable for cleaning the view-
ing window and could affect/damage coloured
printing.
A
B
C
