821042: RMT-170e Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
18
RMT-170e HD Series User Guide
Rear Panel Connectors
•
DVI-I
(DVI-D/VGA/HDMI): Input jack for DVI analog/digital
and requires an adapter for VGA or HDMI input signal.
•
RS485 I/O (RJ45)
: Connector for external control.
Figure 1–6
RS485 RJ45 Connector Pin Map
•
Analog Audio Input 1
: Input jacks for the analog audio signal.
•
Analog Audio Input 2
: Input jacks for the analog audio signal.
•
Analog Audio Output
: Output jacks for the analog audio signal.
•
Power Switch
: Toggling the power switch powers the monitor on
or off.
•
DC Power Connector
: Connect DC power to this four-pin female
connector (12V @ 6A). See the back of the unit for the pin-out
diagram.
•
AC Power Connector
: The power cord connector on this monitor is
on the bottom face of the right side of the back panel. A power
source with the capacity of more than 45W is recommended.
Note:
The DVI-I signal type must be set in the
USER CONFIG
menu of the
OSD Menu
to function correctly.
Table 1–12
RS485 Pin Out
Pin
RS485 In Terminal Signal
RS485 Out Terminal
Signal
1, 2
GND
GND
3
Tx-
Tx-
4
Rx+
Rx+
5
Rx-
Rx-
6
Tx+
Tx+
7, 8
NC
NC
