821042: RMT-170e Series User Guide
© 2011 Wohler Technologies, Inc. All rights reserved.
19
RMT-170e HD Series User Guide
Using the OSD Menu
Using the OSD Menu
A description of how to use the
OSD Menu
follows. Also refer to
Table
1–13
below for typical values and domain range.
1.
Press the
Menu
button to display the menu.
2.
Use the
Up
and
Down
buttons to navigate through the seven
sub-menu icons. The sub-menus are:
A.
STATUS
B.
COLOR TEMP
C.
MARKER
D.
VIDEO CONFIG
E.
AUDIO CONFIG
F.
USER CONFIG
G.
CONTROL
3.
Press the
Enter
button to enter the parameter selections in the
chosen sub-menu.
4.
Use the
Up
or
Down
buttons to cycle through the sub-menu
selections.
5.
When the desired option is highlighted, press the
Enter
button to
select it.
6.
Use the
Up
or
Down
buttons to adjust the parameter value up or
down, make a selection, or turn a function on or off.
7.
Press the
Enter
button to save the parameter change and return to
the sub-menu level.
Press the
Menu
button to back out of a parameter or sub-menu. Press
the
Menu
button again to remove the menu from the screen.
Note:
If you do not press another button for approximately 10
seconds, the menu will disappear from the screen.
