Page
11
(PK) or both with assignable -20db to -18db reference levels.
Waveform
(Y or Line) and/or
Vectorscope
can be shown on the left or right
bottom of the screen.
Closed Captions
from CVBS Line 21 (CEA-608) can be decoded and text is
displayed across the screen bottom. The ‘CC’ logo at screen top center indicates
captions are present in the SDI stream.
The de-embedded
Timecode
from the HD/SD-SDI source displays on the lower
part of the screen. Choose LTC, VITC or D-VITC types in the Display Menu.
Figure 2-2: Display Features
--: --: --: --
HDM-215-3G
SDI1
1080I59.94
HDM-215-3G
Wohler
Input Status
Area Marker
Safety Marker
Center Marker
Audio Level Meters
Waveform / Vectorscope
Timecode
IMD
1.
Input Status
: Displays the detected input and video parameters of the
signal: vertical active line count, (i)nterlaced or (p)rogressive, and
field/frame rate in Hz. This display is controlled be a setting in the Display
Menu. Refer to Table 2-9.
2.
Area Marker
: Used to mark an alternate aspect ratio area of the image. You
can set whether to display it, the brightness, and the matte mode in the
Marker Menu. Refer to Table 2-7.
3.
Safety Marker
:
This is used to mark a percentage area, inside of the image,
safe for titles to be located. You can set whether to display it, as well as its
display mode, in the Marker Menu. Refer to Table 2-7.
4.
Center marker
:
Cross hairs
are
displayed in the center of the screen,
marking the center of the image. You can set whether to display them in the
Marker Menu. Refer to Table 2-7.
5.
IMD
:
The IMD Menu provides settings to customize the IMD (In Monitor
Display) text area to show a static line of characters, numbers, and certain
symbols or to receive dynamic messages to be displayed. Refer to Table 2-
16.
6.
Audio Level Meters
:
Levels for the audio channels are displayed on up to
sixteen bar graph meters as left/right pairs. The meters can appear in
various selectable positions on the screen. Refer to Table 2-8.
