Page
109
System: Factory Reset
The
Factory Reset
function should be used with caution. It deletes all of the
settings you have programmed into the system. It returns the system to the way it
was when received new from the factory. After using this function, you will need to
reprogram everything from the start or else import a Database or the Presets that
you had previously saved. Refer to the
Database Management
section of this
chapter.
Figure 4–36: Factory Reset
If you have any doubt as to whether you should perform a Factory Reset,
do not
click the
Reset
button. Contact Wohler Technical Service for advice.
Note:
Factory Reset
will reset your IP address to the default one (Static IP:
192.168.1.162/Gateway: 192.168.1.1/Netmask: 255.255.255.0) and clear the
database of Presets.
Summary of Contents for iAM-12G-SDI
