Page
11
CHAPTER 2: Local Operation
Startup
The iAM-12G-SDI unit will begin its startup process when it is connected to power.
There is no power switch. It is normal for the product to require about a minute to
start up and be ready to use.
When the iAM-12G-SDI completes its startup, the
Power
indicator will turn green.
Depending upon optional settings, all channel clusters will either be in the muted
condition or set in a predetermined way. You may then touch the meter clusters on
the screen to mute, unmute, or solo channel clusters as needed.
Front Panel
The front panel is shown in Figure 2-1.
Figure 2–1: iAM-12G-SDI Front Panel
1.
Speakers
:
Local near field audio monitoring is achieved through the use of class D
amplifiers. There are two (left/right) full range speakers. The speaker response
may be adjusted with tone controls. Refer to the
Speaker Options
section of this
chapter.
2.
Video Display
:
The selected SDI video signal is monitored on this screen.
3.
Headphone Jack
:
A 1/4" jack for an optional headphone is provided on the front
panel. Speaker audio optionally mutes when headphones are plugged in.
4.
Volume
:
This controls the speaker and headphone output level for the entire mix.
Pressing the knob alternately mutes and unmutes the speaker audio. As you rotate
the knob, the Monitor Info box at the top center of the screen temporarily changes
to an indicator of the Volume setting:
Summary of Contents for iAM-12G-SDI
