Page
23
Back Surround Right
After adjusting the Channel Routing, press the
Adjust B
control
again or touch anywhere on the meters to save the change and
resume monitoring the combination of monitored clusters as before
you soloed the channel.
6.
Phase Indicators
: There is one Phase Indicator per channel pair. It is
pale green when the channels are in phase and bright red when they are
out of phase. Using the
Configuration | System Preference | Phase
Indicator Configuration
tab in the Web GUI, you may determine which
channel pairs should have a Phase Indicator and which shouldn’t, for
example, because they contain unrelated signals.
7.
Loudness Reading
: The Loudness measurement readings can be viewed
on the main
Meter Screen
in the upper left corner. It shows the loudness
measurement calculated on the cluster denoted by the
Loudness Cluster
Selection
bar. Loudness can also be viewed on a dedicated Loudness
screen. Refer to the
Loudness Screen
section and to Figure 2-33 later
in this chapter.
8.
Loudness Cluster Selection
: The
Loudness Cluster Selection
is a
horizontal orange bracket which denotes which channel cluster is being
measured for loudness.
To make a different cluster selection, simply
rotate the
Adjust A
knob. The orange bracket will move from cluster to
cluster as you turn the knob and the loudness measurement will be
restarted on the newly selected cluster.
Summary of Contents for iAM-12G-SDI
