Page
32
Dolby Preset Monitoring Screen
When a Dolby Preset is being monitored, the Dolby codec currently being used
can be displayed, as shown in Figure 2-19, at the center top of the screen.
Figure 2-19: Dolby Preset Monitoring Screen
Note:
If a Dolby Preset was selected as the iAM-12G-SDI is powered down, it
will then reappear when the iAM-12G-SDI is powered up again. However, since
the Dolby Decoder may take several minutes longer than the rest of the system
to power up, the screen may appear as shown in Figure 2-20:
Figure 2-20: Dolby Decoder Startup Delay
If the Yellow indication appears, then waiting a few minutes for the Dolby Decoder
start up to complete will solve the issue and the expected Dolby Zoom screen will
appear.
If the
Brown
indication appears, you may want to power the iAM-12G-SDI off and
then re-power it. If the Brown indication appears on a regular basis, this may
indicate a problem. Please contact Wohler Technical Service to resolve the issue.
Summary of Contents for iAM-12G-SDI
