Page
58
Factory Reset
Touching the
Factory Reset
button in the
System Options Menu
displays the
Factory Reset
screen as shown in Figure 2-51. Because of the large change this
function is about to make to the product, it asks for you for verification that you
really want to proceed.
The
Factory Reset
function should be used with caution. It deletes all of the
settings you have programmed into the system.
It returns the system to the way it
was when received new from the factory.
Figure 2-51: Factory Reset
Factory Reset
Set system to factory
default settings?
No
Yes
Back
Note:
Factory Reset
will also reset your IP address to the default one.
After a Factory Reset, the IP Settings will need to be updated. The default IP
address for the unit is determined based upon the Mac address. It is 169.254.1.xx
where xx is the last octet of the management Mac address. For example, if the Mac
address is b4:ed:54:d0:04:28 then the IP address would be 169.254.1.40 (40 is
the decimal equivalent for the last octet of Mac address 28.)
If you have any doubt as to whether you should press
Yes
, press
Back
or
No
instead, and contact Wohler Technical Service for advice. Pressing
Back
or
No
will
return you to the
System Options
menu.
Summary of Contents for iAM-12G-SDI
