Page
77
Note:
If the
Apply Dolby Zoom Meter Screen
option is turned on and if
Apply
Common Dolby Configurations
is selected while creating a Dolby preset, the
channel clustering shown on the screen follows the
Speaker Configuration
as set
in the
Dolby Configuration
. Otherwise, the channel clustering shown on the
screen follows the speaker configuration selected while creating a Dolby preset.
Note:
The
Loudness
calculations are always done on the Dolby channels, even if
the Preset has other mixed channels.
Refer to Figure 4-12 to configure the Dolby decoder for this Preset.
Figure 4-12: Dolby Decoder Configuration
Click the
Dolby Decoder
tab, as indicated in Figure 4-12. You may then select
from the tabs below it to choose the following:
1.
Decoder Configuration
2.
DD+ Configuration
3.
ED2 Configuration
Each of these tabs contains one or more settings that you can set up to customize
the decoder behavior. Select each one to set them according to your preferences,
to be used in this Dolby Preset only.
Alternatively, if you would rather set up the Dolby Decoder to operate as is set in
Summary of Contents for iAM-12G-SDI
