Page
85
checkboxes.
As shown in the above example, signals appearing on Audio Meter channels 1 and 2
are routed to the Analog XLR outputs. This output is volume and balance controlled
and will follow the Solo/Mutes on the Audio Meter screen.
How do I have a downmixed pre-fade output on Analog DB-25
Pair-1 combined with a post-fade output on the Analog XLRs?
To control whether a specific output is pre-faded or post-faded use the
Volume
Control
setting on the Output Routing configuration page.
In the settings shown above, the Analog XLRs as well as the Analog DB-25 Pair-1
outputs will have a downmix of whatever is being monitored, however the XLR
outputs will be post-fade and DB-25 Pair-1 output will be pre-fade.
How do I make the XLR outputs follow the Audio Meter screen
Solos and Mutes while the Analog DB-25 Pair-1 does not?
When Make the settings shown in the
Solo / Mute
column:
The setting shown above determines that outputs will follow the Audio Meter screen
solos & mutes for the XLR outputs because the checkbox is checked. It is not
checked for Analog DB25 Pair 1, so that will not be affected by the solo & mute
choices.
Summary of Contents for iAM-12G-SDI
