Page
11
Rear Panel
Figure 2-3: Rear Panel Layout
1.
3G-SDI In 1
:
This input connector accepts 3G/HD/SD-SDI video signals. It
is compliant with SMPTE 424M, SMPTE 259M, SMPTE292M/ITU-R BT601. It
can be viewed by making the SDI1 selection with the
Mode
button.
2.
3G-SDI Out 1
:
This connector provides a re-shaped and re-clocked
duplicate of the 3G-SDI In 1 signal. This connection is compliant with SMPTE
424M, SMPTE 259M, SMPTE292M/ITU-R BT601.
3.
3G-SDI In 2
:
This is the second 3G/HD/SD-SDI video signal input. This
connection is compliant with SMPTE 424M, SMPTE 259M, SMPTE292M/ITU-R
BT601. It can be viewed by making the SDI2 selection with the
Mode
button.
4.
3G-SDI Out 2
:
This connector provides a re-shaped and re-clocked
duplicate of the 3G-SDI In 2 signal. This connection is compliant with SMPTE
424M, SMPTE 259M, SMPTE292M/ITU-R BT601.
Important:
The monitor and power adapter have been tested as a combined
apparatus to verify compliance with applicable safety and
electromagnetic compliance standards. Use of another power adapter
provided by the user may negate the compliance or not perform
properly. Wohler Technologies cannot accept any responsibility for the
outcome in such cases.
Important:
By design, the supplied AC mains power cord will only plug into a
three-prong grounded outlet for your safety. If the plug does not fit
into the outlet, contact an electrician to replace the obsolete outlet.
The symbol to the left warns of electric shock hazard inside or outside
the unit. Disconnect the power cord before removing access panels.
