Page
12
5.
CVBS In
: This is the input for an analog CVBS video signal. It can be viewed
making the AV selection with the
Mode
button.
6.
CVBS Out
: The CVBS video signal is repeated on this output.
7.
HDMI In
: An HDMI input is provided. It uses an HDMI Type-A connector. It
can be viewed using the HDMI selection on the IN button menu.
8.
HDMI Out
: The HDMI input is repeated on this output.
9.
L/R Audio In
: A pair of stereo analog audio inputs are provided on RCA
jacks for use when the CVBS selection is made. They have a 20KΩ input
impedance and will accept up to a +5dBu signal.
10.
Left and Right Speakers
: The left and right monitoring speakers for the
unit are located on the rear panel.
11.
Power Connector
:
The supplied 100 to 240VAC to 12VDC power supply
plugs into this coax connector.
12.
Chassis Ground
: This terminal may be used if needed to connect a
grounding wire to the chassis.
13.
Ethernet
:
The 10/100M Ethernet connector is used to connect with a
computer to modify the display settings remotely. CAT5 network cables are
recommended for medium distances. CAT6 twisted pair shielded cables are
recommended for longer distances.
14.
RS-485 In/Out
:
These RJ-45 jacks are used for dynamic Tally/IMD
controls. Two jacks are provided for in & out daisy chain arrangements.
They are wired identically. Refer to Figure 2-5 below for the pinout and
Table 2-2 for terminal connections. These connections are also used for
system software upgrades. Either CAT5 or CAT6 cables may be used for
these jacks.
15.
Tally
:
This RJ45 jack controls the tally lights on the front panel. Refer to
Figure 2-4 for the pinout and Table 2-1 for the terminal connections. Either
CAT5 or CAT6 cables may be used for this jack.
