821704: HDCC-200A (608/708) User Guide
© 2013 Wohler Technologies, Inc. All rights reserved.
13
RM-3270W HD Series User Guide
Using the OSD Menu
•
Input Signal:
The input signal is automatically detected as vertical
active line count, (i)nterlaced or (p)rogressive, and frame rate in Hz.
•
Audio Levels:
Levels for the audio channels are displayed on up to
eight meters as left/right pairs: maximum of four meters on the left
side and four on the right.
•
IMD:
The
OSD MENU
provides settings to customize the IMD (In
Monitor Display) text area to show a line of characters, numbers,
and some symbols.
•
Time Code:
The de-embedded time code from the HD/SD-SDI
source displays in the bottom right corner.
Using the OSD Menu
A description of how to use the
OSD MENU
follows. Also refer to
Table
1–3 on page 13
for typical values and domain ranges.
1.
Press the Menu button to display the menu.
2.
Use the
Up
and
Down
buttons to navigate through the submenus.
3.
Press the
Enter
button to enter the parameter selections in the
chosen submenu.
4.
Use the
Up
or
Down
buttons to cycle through the submenu
selections.
5.
When the desired option is highlighted, press the
Enter
button to
select it.
6.
Use the
Up
or
Down
buttons to adjust the parameter value up or
down, make a selection, or turn a function on or off.
7.
Press the
Menu
button to back out of a parameter or submenu.
Press the
Menu
button again to remove the menu from the screen.
Note:
If you do not press another button for approximately 30
seconds, the menu will disappear from the screen.
