Page
11
7.
Timecode
:
The de-embedded timecode from the HD/SD-SDI source displays
on the lower part of the screen. The timecode setting is located in the Config
Menu. Refer to Table 2-9.
8.
Waveform/Vectorscope/Histogram
:
These can be displayed only for SDI
signals. The waveform and vector of the input signal display are configurable
in the Config Menu. Refer to Table 2-9.
Rear Panel
Figure 2-3: Rear Panel Layout
SDI 1
Out
HDMI
In
RS-485
In/Out
DC
Power
Power
Switch
SDI 1
In
SDI 2
In
Video
In
Headphone
AUD
In
USB
AC
Power
Battery
Holder
Speaker
1.
SDI 1 In
:
This input connector accepts 3G/HD/SD-SDI video signals. It is
Important:
By design, the supplied AC mains power cord will only plug into a
three-prong grounded outlet for your safety. If the plug does not fit
into the outlet, contact an electrician to replace the obsolete outlet.
The symbol to the left warns of electric shock hazard inside or outside
the unit. Disconnect the power cord before removing access panels.
