Working with the camera
42
Charging the batteries
Charge the batteries as follows:
Before you plug the power supply unit into the
outlet, connect it with the camera system.
During the charging process the lower part of the
border around the ON-/Off-key will blink red. After
the charging process has finished it is highlighted
red.
5
Working with the camera
5.1
Turning the camera and the monitor on
VIS 2xx / 3xx
•
Install the memory card (max. 32 GB)
Note!
It is necessary to format the card on the PC first
(FAT 32).
•
Turn on the camera system by pressing the
ON/OFF-key.
5.2
Important notes
Strong electric or magnetic
fields
WARNING!
Do not expose the camera to strong electric or
magnetic fields as caused by television towers,
mobile radio units etc., because they may cause
image interferences.
Exterior influences
WARNING!
Exterior influences as statical discharges may
cause dysfunctions. In this case switch the camera
off and on.