80
•
The internal cooling fans do not come on within two minutes after the projector is first turned on
•
Liquid has been spilled into the projector
•
The projector has been exposed to excessive moisture
•
The projector does not operate normally
•
The projector has been dropped or the case has been damaged
•
Projector performance has deteriorated
Section 5 – Troubleshooting
If the projector is not operating properly, note the symptoms and use this section as a guide to resolve the
problem. If the problem cannot be resolved contact your dealer for assistance.
NOTE: A Wolf Cinema accredited
dealer is required when opening any enclosure to diagnose “probable causes”.
5.1 Power
5.1.1 Projector Does Not Power ON
1. Is the projector plugged in? Check power switch above power cord is in the ON position.
2. Check that the Status LEDs are ON. While the projector is busy initializing, the LEDs should be cycling. When
finished initializing, the Power and Shutter LEDs (the two on the right) should be on.
Summary of Contents for REF-1000
