9
1.2.2 AC /Power Precautions
Use only the AC power cord supplied. Do not attempt operation if the AC supply and
cord are not within the specified voltage and power range. Refer to the license label
on the back of the projector or Section 6 Specifications for rated voltage and power.
The projector is equipped with a 3‐wire plug with a grounding pin. This is a safety
feature. If you are unable to insert the plug into the outlet, contact an electrician to
have the outlet replaced. NEVER defeat the safety purpose of the grounding‐type
plug.
Do not allow anything to rest on the power cord. Locate the power cord where persons
walking on it or objects rolling over it cannot damage the cord.
1.2.3 Lamp Precautions
The xenon lamps are under pressure and may explode causing physical injury and/or
property damage. Never attempt to access the lamp while the lamp is ON. After
turning the lamp OFF, it is crucial that you wait at least 10 minutes before handling the
lamp. This provides sufficient time for the lamp cooling fans to properly cool the lamp.
For all other precautions critical for safe removal and replacement of the lamp, refer to
Section 4.1.1.
Summary of Contents for REF-1000
