Wolf Garten A 400 E, Original Operating Instructions

Operating instructions lawnmower

17

Installation

English

After using the lawnmower



Switch the lawnmower off and then place 

it in a safe location.



Before performing maintenance or cleaning work 

on the lawnmower, switch the lawnmower off and 

pull out the mains plug and remove the grass 

catcher bag.



Ensure that the ventilation slots are clean.



Do not keep the lawnmower near children.



Do not repair the lawnmower yourself, but have 

it repaired by a qualified technician or the service 

centre only.

Cable

Attention! Electric shock due to damaged 

cable! The fuse will not always trip if the 

cable is severed or damaged.



Do not touch the cable until the mains plug has 

been pulled out of the socket.



Have damaged cables repaired by an electrician 

or the service centre. It is forbidden to repair 

the cable with insulating tape.



Attach the power cord to the cable strain relief 

and do not let it rub against edges or pointed 

or sharp objects.



Do not crush the cable in a door crack 

or window gap.



Do not remove or bypass any switching 

devices (e.g. connection of the safety lever 

to the handlebar).



Use outdoors with the permitted and appropria-

tely identified power cord only, e.g. H07RN – 

F 3 x 1,5 mm

2 

(max. 25 m).



Connecting parts of the power cord must 

be splash-proof and made of rubber 

or covered with rubber. 

Disposal

Installation

Attaching the handlebar



Caution! When collapsing or unfolding the 

handlebar, the cable may be damaged. 

Ensure that the cable is not kinked.

Assemble the handlebar according to Figures 



and 





as follows:



Take hold of the recessed grip in the discharge 

flap 



 and pull the discharge flap upwards 

until the hook on the back of the housing and the 

hook on the underside of the discharge flap 

disengage with a loud “click” 



.



Then put the discharge flap down again 



. 

The grass can be discharged without difficulty 

through the gap between the discharge flap and 

housing when working without a grass catcher 

bag. Further information can be found in the 

chapter “Working without a grass catcher bag”.



Now attach the two handlebar holders 



to the lower part of the handlebar 





.



Place the lower part of the handlebar on the 

handlebar holder and press them together 



. 

Push the handlebar up to the end of the handle-

bar holder 



.



Pull the ends of the lower part of the handlebar 

apart slightly and place them on the threaded 

screws which are on the left and right sides 

of the housing 



.



Then place the two washers 



 on the threaded 

screws 



.



Insert the threaded bolts 



 into the quick-

clamping levers 



 so that the hole can be seen 



. Hold them firmly between thumb and index 

finger and screw on the quick-clamping levers 

and threaded bolts clockwise 



until they 

are at a distance of ~10 mm 



.



Attach the lower part of the handlebar by folding 

the quick-clamping lever upwards in the direction 

of the lawnmower 



.



Then attach the upper part of the handlebar 



by placing it on the lower part of the crossbeam 



. Hold the upper part of the handlebar firmly 

with one hand and insert the two screws 



 with 

the other hand into the holes from the inside 

on the lower part of the handlebar 



.



Then place the two washers 



 on the 

screws



.

Do not throw lawnmowers into 

the household refuse. 

Have the lawnmower, accessories and 

packaging disposed of in an environ-

mentally friendly manner.