34
W415-1600 / 06.01.16
J
no ignition
the appliance may fail to light becauSe the auger and/or hopper iS empty and not alwayS
able to load the burn pot with the neceSSary quantity of pelletS in time to regularly
ignite the flame.
if the problem occurS after only a few monthS of operation, check that the cleaning
routine indicated in thiS manual haS been carried out correctly.
13.1 general menu
kEy
FUNCTION
OK
OK
Scroll parameters
Modify settings
OK
on - oFF key
kEy
FUNCTION
Back - exit key
OK
Menu access key
uSer Menu
% pelleTS
% v1 Fan
reSeT
SeT cHrono
enaBle cHrono
SeT prg1
SeT prg2
SeT prg3
ducTing
Z1 Mode
SeT prg4
SeT Zone Z1
Z1 Fan %
Z2 Mode
SeTTingS
SeT clocK
SeT Zone Z2
language
Z2 Fan %
diSplay
STandBy
delTa T
inSTallaTion Type
*appliance STaTuS
*TecHnical
Menu
*TecHnicianS only
baSic inStructionS
The following recommendations must be followed the first time
the appliance is ignited:
it is possible that slight odours are produced due to the
drying of the paints and silicone used. do not remain in the
room for long periods.
do not touch the surfaces as they could still be unstable.
ventilate the room well several times.
The hardening of surfaces will stop after several heating
cycles.
This appliance must not be used to burn waste.
Before lighting the appliance, the following points must be
checked:
The hopper must be full of pellets
The combustion chamber must be clean
The burn pot must be completely free of ash and clean
check the seal of the firebox door and the ash drawer
check that the power cable is properly connected
The on/oFF switch located on the rear panel left side must
be positioned on (i).
Summary of Contents for Vicenza V5.2
