6
|
Wolf Customer Care 800.222.7820
INSTALLATION
2
Place the mounting tabs over the mounting screws. Use
the leveling adjustment screws to ensure the hood is
level. Refer to the illustration below.
3
Mount the electrical plate to the wall using screws
provided.
4
Place the backdraft damper on the round discharge then
install 6"
(152)
round metal ducting (not provided) to the
damper and seal with aluminum tape.
5
Make wiring connections. Refer to page 9.
6
Once wiring connections are complete, secure the upper
chimney flue to the mounting brackets using screws
provided. Refer to the illustration below. Place the lower
chimney flue over the upper, then lower until it rests on
the hood.
Installation
WALL HOOD
If an internal blower will be used, install the blower prior
to mounting the hood. Refer to page 8 for internal blower
installation.
1
Mark the center line for location of two mounting holes
using dimensions shown in the chart and illustration
below. Additional wall framing is recommended in this
location. If wall framing is not available, the use of wall
anchors is recommended. Install the mounting screws
so there is approximately
1
/
4
"
(6)
gap between the screw
head and wall. Position the two mounting brackets for
the chimney flue, then install using two mounting screws
per bracket. Refer to the illustration below.
MOUNTING LOCATION
SCREW LOCATION
A
Black Hood
12
3
/
4
"
(324)
Stainless Hood
16
3
/
8
"
(416)
Glass Hood
12
9
/
16
"
(319)
BOTTOM OF HOOD
CEILING
A
9
1/8
"
(232)
17
1/16
"
(433)
3/4
"
(19)
Mounting location.
MOUNTING
TAB
LEVELING
SCREW
Mount and level hood.
Install telescopic flue.
