Page 13
Cup Warming Drawer (CW24)
Cup Warming Drawer (CW24)
Component Removal
3-6
#9001337 - Revision A - September, 2015
Figure 3-10. Cavity Top
Cavity Top
To remove the cavity top, first remove the tray and front
cover as an assembly from the cup warming drawer,
then (See Figure 3-10):
1. Use a T-20 to extract the six screws, three on each
side.
2. Use a T-20 to extract the three screws at the back
bottom of the cavity top.
3. Remove the cavity top.
Right and Left Trim
To remove the right or left trim, first remove the cavity
top, then (See Figure 3-11):
1. Use a T-20 to extract the two screws from the trim
piece.
2. Rotate the back of the trim piece forward.
3. Slide the trim down the support tab and off the unit.
Cavity Cover
To remove the cavity cover, first remove the cavity top,
then (See Figure 3-12):
1. Use a drill to drill out the seven M3 x 5 mm pop riv-
ets on each side of the unit
2. Pull the cavity cover forward out of the unit.
NOTE:
Order new pop rivets from the Parts Manual.
Lower Trim, and Upper Trim
To remove the lower and upper trim, first remove the
cavity top, then (See Figure 3-12):
1. Use a drill to drill out the seven M3 x 5mm pop riv-
ets.
2. Remove the upper and lower trim.
NOTE:
Order new pop rivets from the Parts Manual.
Figure 3-11. Right and Left Trim
Figure 3-12. Cavity Cover, Lower and Upper Trim
