Component Access & Removal
4-17
D
Du
ua
all F
Fu
ue
ell R
Ra
an
ng
ge
e
Door Adjustments
To adjust doors for height use a 5/32” allen wrench to
turn the allen screw for the hinge pocket. This will raise
or lower the oven door to the desired height allowing for
proper alignment between the bull nose and the top of
the oven door. Do this procedure for each side of the
oven door until the desired alignment is obtained. (See
Figure 4-35 and 4-36)
Door Gasket Removal
First, open the oven door. Now, locate the small clips
attached to the underside of the gasket and gently pull
the clips from the mounting holes. Next, pull the ends
of the gasket out from the bottom of the door liner and
remove. (See Figure 3-37).
NOTE:
On units starting with serial #16000000 the
gasket will be mounted to the front collar of the cavity.
Removal procedure is the same.
Figure 4-37. Door Gasket Mounting
Figure 4-36. Alignment between Bull Nose and Door
Figure 4-35. Use a 5/32” Allen Wrench to Adjust Door
Door(s) Reinstallation (Continued)
Then, position door in hinge openings at a 30° angle
from vertical. Now, insert spring side hinge into hinge
pocket. Next, lower door to fully opened position and
remove hinge pin. Reinstall plate and screw over hinge
opening. Then, open and close door to insure its prop-
erly installed.
NOTE:
On units with a new style single hinge retainer
plate (See Figure 4-34A), you will need to install the
single hinge retainer onto the hinge claw prior to
installing door.
NOTE:
If replacing old style hinge retainer with new
style (See Figure 4-34A), you will be required to drill a
9/64” hole for the lower screw once door is installed and
prior to installing skirt.
For 48-inch and 60-inch units, complete this procedure
for both the left and right oven doors.
Hinge
Retainer
Plate
Hinge
Pin
Old Style
New Style
Figure 4-34A. Old style and New Style Hinge Retainer
Failure to screw in the bottom screw will lead to
future failure. The hole must be drilled and used to
secure the bracket.
Summary of Contents for DF304
