Component Access & Removal
4-19
D
Du
ua
all F
Fu
ue
ell R
Ra
an
ng
ge
e
Figure 4-42. Convection Baffle Removal
Oven Compartment Components
Left and Right Rack Guide Removal
First, remove oven racks. Then, extract the screws in
each corner, top and bottom of the rack guide and lift
guide out.
NOTE:
On units starting with serial #16000000 the
oven rack guides remove without extracting any screws.
Simply lift upwards on the rack to disengage the shoul-
der screw from the keyhole slot on the rack guide and
remove. (See Figure 4-41)
Oven Light Removal
To remove the oven light you will need to remove the
oven racks and guides. Next, the light cover will need
to be removed by gently pulling the light cover off the
light housing. Now, to remove the light bulb, lift the
bulb straight up and out of the light bulb socket.
NOTE:
When replacing the light bulb with a new one,
wrap a clean cloth around the new bulb so fingerprints
are not left on the new bulb. The greasy residue from
fingerprints may cause the new bulb to burn out prema-
turely.
Convection Baffle Plate Removal
First, the racks and rack guides will need to be
removed. Now, extract the screws in each corner, the
top and bottom of the convection baffle plate and
remove. (See Figure 4-42)
Convection Fan Assembly Removal
The racks, rack guides and convection baffle plate will
need to be removed first. Then, extract the screws
around the convection fan and the top screw located
between the element (where the element goes through
the oven cavity). (See Figure 4-43) Now, pull fan
assembly into oven cavity and disconnect wiring and
remove.
Broil Element and Broil Pan Removal
To have more room when removing the broil element,
remove the racks from the unit. Next, extract the four
screws that secure the element and broil pan to the
ceiling of the oven cavity. Now, extract the two screws
that secure the element leads through the oven cavity.
Then, pull the element forward and down into the oven
cavity until the terminals and wires are exposed. Now,
disconnect the wires and remove the element and broil
pan. (See Figure 4-44)
Smoke Catalyst Removal
The catalyst is located in the rear ceiling of the oven
cavity. To remove, extract the two screws and pull cata-
lyst straight down and remove. (See Figure 4-44)
Figure 4-44. Broil Element and Smoke Catalyst Removal
Figure 4-43. Convection Fan Removal
Figure 4-41. Removable Rack Guides
Summary of Contents for DF304
