Remove the Bake Tray Assembly
1
Use a T-20 Torx bit to loosen the bake tray support screws.
The bake tray supports should drop down, creating space
to remove the bake tray assembly. If the bake tray support
screws are backing out, use the T-20 Torx bit to push the
bake tray support screw in.
2
Pull the bake tray assembly forward.
3
Remove the cavity bottom panel.
4
Disconnect the bake element wire connectors from the rear
of the bake element.
5
Pull the bake tray assembly forward from the unit.
BAKE TRAY ASSEMBLY INSTALLATION
After installing the bake tray assembly, install:
1
2
3
4
Install the Bake Tray Assembly
1
Connect the wire connectors to the bake tray assembly.
2
Place the bake tray assembly into the unit.
3
Place the cavity bottom panel onto the bake tray assembly.
4
Push the bake tray assembly back to the rear wall.
5
Use the T-20 Torx bit to tighten the bake tray support
screws.
6
Make sure the cavity bottom panel is tight and flush with
the left and right cavity sides.
30" and 36" Induction Range
Cavity Component Removal and Installation
Remove the Bake Tray Assembly (continued)
service.subzero.com
829191 REVA
63