6
Remove the cover collar from the unit.
COVER COLLAR INSTALLATION
After installing the cover collar, install:
1
2
Install the Cover Collar
1
Thread the lower part of the cover collar over the hinges.
2
Push the top of the cover collar back.
3
Use a
3
/
16
" Allen wrench to install the door bumper over the
door switch.
4
Use a T-15 Torx bit to install the door bumper on the right
side.
5
Use a T-20 Torx bit to install the lower screws.
EXHAUST DUCT REMOVAL
To remove the exhaust duct, first remove:
1
2
3
Remove the Exhaust Duct
1
Use a T-20 Torx bit to remove the front duct screws.
2
Remove the front duct from the unit.
3
Use a T-20 Torx bit to remove the bottom access cover
screws.
4
Remove the bottom access cover from the unit.
EXHAUST DUCT INSTALLATION
After installing the exhaust duct, install:
1
2
3
Install the Exhaust Duct
1
Place the bottom access cover into the unit.
2
Use a T-20 Torx bit to install the bottom access cover
screws.
3
Place the front duct into the unit.
4
Use a T-20 Torx bit to install the front duct screws.
HINGE REMOVAL
To remove the hinge, first remove:
1
2
3
Remove the Hinge
1
Use a T-15 Torx bit to remove the hinge screw.
30" and 36" Induction Range
Cavity Component Removal and Installation
REMOVE THE COVER COLLAR (continued)
service.subzero.com
829191 REVA
57