Dual Fuel Range Installation
16
Electrical Connection
The terminal block on the rear of the range allows for a
3-wire or 4-wire installation. For a 4-wire installation, the
ground strap from the unit to the terminal block must be
cut. Two concentric knockouts are provided to allow for
permanent or cordset wiring of the unit.
THREE-WIRE ELECTRICAL SYSTEM
1)
Where local codes permit, connect the ground appli-
ance wire to the neutral (white) supply wire.
2)
Connect the ground and white appliance wires to the
neutral (white) supply wire in the electrical box.
3)
Connect the black appliance wire to the black (L1)
power supply wire in the electrical box.
4)
Connect the red appliance wire to the red (L2) power
supply wire in the electrical box.
FOUR-WIRE ELECTRICAL SYSTEM
1)
Separate the ground and white appliance wires.
2)
Connect the white appliance wire to the neutral (white)
supply wire in the electrical box.
3)
Connect the black appliance wire to the black (L1)
power supply wire in the electrical box.
4)
Connect the red appliance wire to the red (L2) power
supply wire in the electrical box.
5)
Connect the ground appliance wire to the green/
ground house grounding wire in the electrical box.
Verify that power is disconnected from the electrical
box before proceeding.
Oven Door Removal
OVEN DOOR REINSTALLATION
1)
Hold the oven door on both sides and position it with
door hinges aligned with openings in the oven frame.
2)
Holding the oven door at an approximate 30° angle
from vertical, slide the hinges into the openings
until the bottom hinge arms drop fully into the hinge
receptacles.
3)
Open the oven door to its fully opened position.
Remove the hinge pin from the appropriate hinge arm.
Refer to the illustration below.
4)
Reinstall the hinge retainer plate with upper and lower
mounting screws.
5)
Open and close the door completely to ensure that it is
properly installed.
6)
Reinstall the lower kickplate assembly.
IMPORTANT NOTE:
Fully extend the hinge claw which is
opposite the hinge pin location and insert into the hinge
pocket prior to inserting opposite side. This will ease the
installation of the oven door.
KICKPLATE
UPPER
MOUNTING
SCREW
HINGE
RETAINER
PLATE
HINGE
PIN
Oven door reinstallation.
