Wolf Built-In Ovens
5
wolfappliance.com/specs
E SERIES SINGLE OVENS
Required power supply:
Single phase: 220-240V AC; 50/60 Hz
3phase: 380-415V AC; 50/60 Hz
Maximum connected load:
Single phase: 4.4 kW
3phase: 4.4 kW
Total amps:
Single phase: 19 amps
3phase: 19 amps
E SERIES DOUBLE OVENS
Required power supply:
Single phase: 220-240V AC; 50/60 Hz
3phase: 380-415V AC; 50/60 Hz
Maximum connected load:
Single phase: 7.4 kW
3phase: 5.1 kW
Total amps:
Single phase: 32 amps
3phase: 22 amps
Refer to the wiring diagram showing the connections for
each lead to the terminal box on the unit.
Planning Information
STANDARD INSTALLATION
For ease of installation, Wolf recommends using 838 mm
wide cabinets with 762 mm ovens. You will need a
minimum 610 mm of usable cabinet depth. The cabinet
must be able to support 113 kg for a single oven and 181
kg for a double oven.
The oven has a face trim on all four sides and will overlap
stiles and rails. Refer to the chart for overlap dimensions.
Oven Trim Overlap
OVEN TRIM
E SERIES
Top Overlap
16 mm
Bottom Overlap
3 mm
Side Overlap
19 mm
N
L1
Single phase wiring diagram.
3phase wiring diagram.
N
L1
L2
L3
˜
FLUSH INSET INSTALLATION
A flush inset installation requires the oven to be recessed
into the cabinet. A minimum 635 mm deep cabinet is
needed if you want the front of the oven to be flush with
surrounding cabinetry.
Electrical Requirements
IMPORTANT NOTE:
Be aware of local codes and ordi-
nances when installing your service.
The single and double ovens require a separate, grounded
220-240 V AC, 50/60 Hz power supply and uses the
power inlet box. Refer to the illustration below. Total amps
for single ovens is 21 and for double ovens, 37.
3N
˜