Induction Range (IR) Series
Induction Range (IR) Series
Component Removal
3-2
#827176 - Revision A.1 - December, 2016
COMPONENT REMOVAL
This section explains how to remove components from a Wolf Induction Range (IR) Series. Depending on which
component you are going to remove, you may have to remove other components first. Refer to the appropriate sec-
tion in this manual that explains how to remove those various components. When reassembling, just reverse the
steps that were used to remove the components.
NOTE:
Before attempting to access or remove any components from a Wolf appliance, take note of the WARN-
INGS and CAUTIONS below.
•
TO AVOID ELECTRIC SHOCK, POWER TO THE UNIT MUST BE DISCONNECTED WHENEVER SERVICING
AND/OR ACCESSING COMPONENTS.
•
KEEP IN MIND THAT UNIT SURFACES AND COMPONENTS GET HOT DURING USE OF THE APPLIANCE.
•
PULLING A UNIT FROM ITS INSTALLATION SHOULD ONLY BE PERFORMED BY A CERTIFIED SERVICE
TECHNICIAN OR INSTALLER.
•
When working on the induction range and components, be careful when handling sheet metal parts. They
may have sharp edges.
Tools Needed
6-Lobe Torx type driver size T-15
•
6-Lobe Torx type driver size T-20
•
6-Lobe Torx type driver size T-25
•
Phillips screw driver
•
Small flat blade screw driver
•
Flat blade screw driver
•
Needle nose pliers
•
Putty knife
•
5/32” Allen wrench
•
5/8” Box wrench
•
