Induction Range (IR) Series
Induction Range (IR) Series
Component Removal
3-10
#827176 - Revision A.1 - December, 2016
Alternate Method For Bullnose Removal (suction
cup required)
There is an alternate method for removing the bullnose
that removes the need to pull the unit from the installa-
tion, but requires the use of a suction cup.
To remove the bullnose without pulling the unit from the
installation or removing the induction cooktop (See
Figure 3-21):
Extract the screws from under the bullnose.
1
Place the suction cup on the front center of the
2
induction cooktop.
Lift the induction cooktop and bullnose about one
3
inch.
Move the bullnose up and down to disengage it
4
from the shoulder screws on the bullnose and the
face of the unit.
Disconnect the wire harness from the ECH.
5
Remove the bullnose.
6
Side Panel Removal
The side panels are attached to the front and back of
the unit, with the induction cooktop resting on top of
them.
To remove a side panel, first remove the induction
cooktop, and the bullnose, then (See Figure 3-22):
Extract the screws from the rear of the side panel.
1
Extract the screws from the front of the side panel
2
and oven trim.
Remove the side panel and oven trim.
3
Probe Switch Removal
The probe switch is located behind the right hand side
panel.
To remove the probe switch, first remove the right side
panel, then (See Figure 3-23):
Remove the probe cover from the interior of the
1
oven (see page 3-7).
Extract the screw to remove the meat probe access
2
cover.
Pull the probe switch from the insulation.
3
Disconnect the electrical leads from the probe
4
switch.
Remove the probe switch.
5
Figure 3-21. Alternate Bullnose Removal Method
Figure 3-22. Side Panel Removal
Figure 3-23. Probe Switch Removal
