18
3040530_201503
Applied test force (F) and deflection values (x) for high performance narrow V-belts DIN 7753
Belt profile
Effective diameter
of the small pulley
(mm)
Force F
(N/belt)
SPZ
67 - 95
100 - 140
150 - 200
10 - 19
15 - 20
19 - 27
SPA
100 - 132
140 - 200
224 - 315
20 - 27
28 - 35
35 - 50
SPB
180 - 224
236 - 315
315 - 400
400 - 500
40 - 52
46 - 60
55 - 76
67 - 90
Deflection x (mm)
Axle centre A (mm)
Maintenance
Before starting any maintenance work, turn the system ON/OFF switch OFF
and secure against reconnection. If it is switched ON again unintentionally,
people who enter the unit are at risk from rotating parts.
Wait for the fan to come to a complete standstill before opening the inspection
doors. When the doors are opened, negative pressure may draw in loose
objects, which could destroy the fan or even cause a risk to life if items of
clothing (ties) are drawn in.
Fan section
ca
.
1
5
m
m
V-belt
tensioning
screw
Initially recharge fan bearings with grease nipples with lithium soap grease after
approximately 50 hours run, and then every 2500 hours run.
Maintenance-free bearings are permanently lubricated and are identified
accordingly with labels.
Standard three-phase motors are maintenance-free.
In the case of special motors, follow the maintenance instructions of the motor
manufacturer.
Initially adjust the tension of V-belts after one hour in use. After this, checks at
regular intervals are required depending on the operating conditions, but should
be carried out at least every 4 months.
When changing the V-belt in multi groove drives, replace the entire belt set.
In the KG 40-100 Standard, the drive motor is attached to a sloping frame.
To adjust the tension of the V-belt, undo the locknut on the tensioning screw,
tighten the tensioning nut to the correct belt tension, and retighten the locknut.
Correct V-belt tension:
After tightening, the V-belt at the halfway point between the motor and fan shaft
must be able to be deflected by about 15 mm.
Check that the V-belt pulleys are aligned.
Please note
approx. 15 mm
Summary of Contents for KG Standard
Page 22: ...22 3040530_201503 Notes ...
Page 23: ...3040530_201503 23 Notes ...
