6
|
English
4
Aligned with mounting cut-outs on the back panel, lift
the hood into position onto the brackets. Secure with
screws and washers through mounting holes. Verify
screws engage the mounting strip. Refer to the illustra-
tions below. If additional support is required, drill supple-
mentary holes through the back panel and secure with
screws.
5
Make electrical connections.
6
Connect 254 mm round metal ducting to the damper
with screws and seal with duct tape.
7
Reinstall filters.
Installation
WARNING
Wall framing must be able to support the weight of the
hood and internal blower, if applicable.
1
Refer to the illustration below for typical wall framing.
Additional framing or blocking is required in the
mounting location of the hood.
2
A wood mounting strip and hardware are provided with
the hood. Position the mounting strip on the wall as
shown in the illustration below. Secure the mounting
strip to wall framing and blocking with screws.
3
Install mounting brackets to the mounting strip. Brackets
should be positioned 13 mm above the mounting strip
and as indicated in the chart and illustration below.
Secure the brackets using screws and washers.
MOUNTING BRACKET LOCATION
A
76 cm Hood
597 mm
91 cm Hood
622 mm
107 cm Hood
775 mm
122 cm Hood
927 mm
152 cm Hood
1232 mm
MOUNTING
CUT-OUTS
MOUNTING STRIP
Mounting cut-outs.
Hood installation.
INSTALLATION
Electrical Connections
WARNING
Before making electrical connections, verify power is
turned off at the service panel.
IMPORTANT NOTE:
Refer to installation instructions pro-
vided with each blower assembly for specific mounting and
wiring instructions.
INTERNAL BLOWER
1
Remove the hood’s electrical box cover. Insert electrical
cable from the service panel into the electrical box. Do
not remove the connector on the orange wire in the box.
2
Using wire connectors provided, connect black to black,
white to white and green/bare wires to the ground screw.
3
Place all wiring connections inside the electrical box and
reinstall the cover. Verify all wires are secure and not
pinched between the cover and electrical box.
4
Plug the blower’s power cord into the receptacle inside
the hood. Secure excess cord with interior clips. Turn
power on and check operation.
CL
BLOCKING
MOUNTING
STRIP
384
mm
13
mm
A
MOUNTING BRACKET CENTERS
BACK
PANEL
Wall framing (typical).
IN-LINE | REMOTE BLOWER
1
Remove the hood’s electrical box cover. Insert electrical
cable from the service panel and from the in-line or
remote blower into the electrical box.
2
Using an appropriate connector, connect the black wire
from the blower to the orange wire in the hood.
3
Connect leads from the cord assembly to leads from the
blower. Using wire connectors provided, connect black
to black, white to white and green/bare wires to the
ground screw.
4
Place all wiring connections inside the electrical box and
reinstall the cover. Verify all wires are secure and not
pinched between the cover and electrical box.
5
Plug the cord assembly into the receptacle inside the
hood. Secure excess cord with interior clips. Turn power
on and check operation.
